DS200TBQAG1ABB RST ANALOG TERMINATION BOARD

Specifications

Part No.: DS200TBQAG1ABB
Manufacturer: General Electric
Series: Mark V
Product Type: Analog Termination Board

Two 90-pin terminal blocks on the GE RST Terminal Board DS200TBQAG1ABB support a maximum of 180 signal lines. TB1 and TB2 are the names of the terminal blocks. Three 20-pin connectors are also included on the GE RST Terminal Board DS200TBQAG1ABB.

• The written instructions that come with the GE RST Terminal Board DS200TBQAG1ABB outline the signal connections that can be made to the terminals when you initially install them. After you've figured out which terminal to attach a signal wire to, you'll need to remove the insulation from the signal wire's end to expose around 0.5 inches. The wire should then be inserted into the terminal after loosening the screw. To secure the wire, tighten the screw. Pull the wire gently to make sure it's securely fastened in the terminal and can't be easily withdrawn.
• When replacing the board, however, all you have to do is remove the signal wires from the old one and put them in the same terminal on the new one. Because you may have numerous signal wires to reconnect, you must be careful to connect them to the correct terminal. Before you begin, make sure you have somebody who are qualified to turn off the drive's power. Installers who are knowledgeable with the drive's installation will be familiar with the power, signal, and ground wiring. An electrician who is familiar with the setup would be qualified to turn off the electricity.
• Some capacitors on the drive's boards maintain power even after the drive is turned off. The power exits the capacitors and other components after 30 seconds, and the board is free of the current.

World of Controls has the most extensive selection of Speedtronic Mark V control spare parts. At any time, WOC's professionals are accessible to assist you with your GE Mark V requirements. If you require any additional information, please contact us.

Frequently Asked Questions

What is DS200TBQAG1ABB?
DS200TBQAG1ABB is an Analog termination board under Mark V series.

How many Terminal blocks and connectors are included in DS200TBQAG1ABB?

The GE RST Terminal Board DS200TBQAG1ABB has two 90-pin terminal blocks that can support up to 180 signal lines. The terminal blocks are designated by the letters TB1 and TB2. The GE RST Terminal Board DS200TBQAG1ABB likewise has three 20-pin connectors.

How to obtain DS200TBQAG1ABB?

Call or mail the World of Controls team. WOC provides DS200TBQAG1ABB boards and other turbine control components.