[email protected]
+1 832 946 3166
Instagram

DS3800HSQD1J1F

DS3800HSQD1J1F - GENERAL ELECTRIC SEQUENCE ASSEMBLY PCB

DS3800HSQD1J1F - GENERAL ELECTRIC SEQUENCE ASSEMBLY PCB DS3800HSQD1J1F - GENERAL ELECTRIC SEQUENCE ASSEMBLY PCB

World Of Controls understands the criticality of your requirement and works towards reducing the lead time as much as possible.

DS3800HSQD1J1F - GENERAL ELECTRIC SEQUENCE ASSEMBLY PCB is available in stock which ships the same day.

DS3800HSQD1J1F - GENERAL ELECTRIC SEQUENCE ASSEMBLY PCB comes in UNUSED as well as REBUILT condition.

To avail our best deals for DS3800HSQD1J1F - GENERAL ELECTRIC SEQUENCE ASSEMBLY PCB, contact us and we will get back to you within 24 hours.

Request For Quote
Contact Us

Featured Product

SPECIFICATIONS

Part No.: DS3800HSQD1J1F
Manufacturer: General Electric
Product Type: Low HP Sequence Board
Series: Mark IV

The GE DS3800HSQD1J1F is a Low HP Sequence Board from the the Mark IV series. The board has one hole in each corner where screws can be inserted to hold the board in the drive. Two 40-pin connectors and one 20-pin connector with retention levers lock the ribbon cables on the GE Low HP Sequence Board DS3800HSQD1J1F. A 50-pin connector and one 20-pin connector are also included on the surface of the board. 1 erasable programmable read-only memory (EPROM) module, 1 amber indication LED, and 8 red indicator LEDs are featured on the board.

  • A daughter card may be put on the GE Low HP Sequence Board DS3800HSQD1J1F that you plan to replace. The daughter card is a device that can be used with the board but is not required. It increases the board's functionality. Signals are sent to the board by the daughter card. The board also sends signals to it. It also draws current from the board to power the daughter card. The daughter card can be taken out and replaced on the new board.
  • When removing and installing the daughter card, wear a wrist strap. Disconnect the 50-pin ribbon cable before removing the daughter card. Hold the connector with one hand and pull it out of the board's connector with the other. Then, one at a time, raise one corner of the daughter card from the standoffs.
  • Place the card in a static protection bag while holding it with two hands. Keep the card somewhere clean and dry until you're ready to put it on the replacement board.


The most comprehensive catalog of GE Speedtronic Mark IV control components may be found at World of Controls. Our experts are ready to assist you with your Mark IV requirements. Please contact WOC straight away if you require any additional information.

 

Frequently Asked Questions

 

What is DS3800HSQD1J1F?
DS3800HSQD1J1F is a Low HP Sequence Board developed by GE under Mark IV series.

How to Obtain DS3800HSQD1J1F?
World of Controls provides DS3800HSQD1J1F as well as other turbine control products. Contact WOC.